bottom sidewall holes

[FeelTheRain]

i just got my torque, and when i was just about to tie p my sidewall, i noticed the holes were way too small for the faqt jimalax tips to fit through. Right now i am using the outer bottom string holes but may just keep it like that. HHOw does everty1 else make thses holes open up wider.

[lzlax09]

Melt the tip of the sidewall string and with a kleenex pull it to make it a tip wait for it to harden then put it through. If it doesn't go through all the way just use plyers to pull it on through. Otherwise just leave it like it is.

[Jjaylax09]

i had a problem with stringsbeing too large on a head i was stringing one time and i just took a drill bit that was slightly than the hole already there and just drilled it out

[laxdevil666]

thats what i did, it does how ever void the warenty, but i got mine down at the final four, so there was no warenty. other than that, just use the last big hole, adn wrap the string throught it like 3 times so the knot doesn't pop throught the hole.