{HELP/DYE} i want to do this rasta dye

[vegasboy]

hey,

i need some help i wnat to dye my pp like this but i dont know how?

http://inlinethumb51.webshots.com/33138/2198677580101001291S425x425Q85.jpg (http://good-times.webshots.com/photo/2198677580101001291wcRkIP)

[min_sarker]

only way i can tell you is kinda hard

dye bottom yellow, then top red

then tape the yellow and red u wanna keep

then dye black and dye green

then take tape off and ur done!

[vegasboy]

ok but where it kinda seperates i want it white or is it easier to do with no white

[BeaverFondu]

you just have to have hot glue
on the places where you want white
do it at the start
don't take it off at all during the process

[rubeo990]

You could leave tape or hot glue on over the white the whole time. No problem there.

[dalaxmandef3]

I think it would look much better without the white lines, but hey whatever you like better.

[aviator]

start with the lighter colors, use ALOT of glue or tape. If you use tape, make sure its electrical tape and that you seal the edges with glue. IMO it would look better without the white, but whatever you wantttttt

[vegasboy]

ill do it with out the white then so do i die the bottom yellow and top red then go from there?

[vegasboy]

what happens if i also make the dye like this.

you take the red at the bottom then you make it like this / then yellow like that agin then green then black?

[warriorlaxboy1]

What I would do is put glue around where you want white, and then dip the head at angles. That way, even if it gets close to the other color, the glue is there. I'm pretty sure that would work perfect, because on my most recent dye i did angles and it worked out great (it didn't come out great) but the colors were where i wanted them

[vegasboy]

im not going to do the white anymore

[warriorlaxboy1]

Then just dye a corner and put glue on that color while you do the other corner on each side of it.