nitrous sidewalls

[woolax246]

Any1 have any suggestions on how to string a nitrous' sidewalls. It has so many holes and i get confused.

[LFLax12]

just skip a hole every time, like so

0o0o0o0o0o0o0o

the 0's are holes you'd put the string through
the o's you would leave empty

[Tman188]

it dosent matter just make sure they are the same on both sides

[Superman]

just skip a hole every time, like so

0o0o0o0o0o0o0o

the 0's are holes you'd put the string through
the o's you would leave empty


thats great stuff :nahya:

[Lax101]

On the nitrous sidewalls, they mark off the suggested holes you should string it in. I think each "suggested" hole has a triangle imprint surrounding it.

[RedStormLaxer41]

lax101 is right, although i found that there was no hold when i strung mine that way, so what i did was i strung in every hole BEFORE that suggested one... it just made it bag a little bit more to my liking

[laxer41]

Well, isnt it easier to string with lots of holes?? then u can customize it to your liking. I have a nitrous, and the sidewalls was the easiest part of the entire stick.

[MinnetonkaLax]

i find it kind of hard because when your stringing just normal mesh it is a little harder to know which ones you should use, but as Lax101 said, they mark the suggested holes

[sailorslax88]

just see what holes in the mesh correspond to holes in the sidewall

[Trilax03]

just see what holes in the mesh correspond to holes in the sidewall

you can do that or just get a picture of a strung one and see how they did it

[laxkid009]

yea i have a torque and it was so easy to string the side walls since there r so many. but u could always unstring and restring the sidewalls untill you get them to your liking