troubles in stringing soft factory mesh

[laxlover8]

Those Brine complete stick's factory soft mesh is bad!
the fabric is really soft and I have tried every strining method I know but still, there is whip (or you may say great great hold) which make the ball hard to leave the pocket....
are there any good stringing to deal with the soft mesh?
I use the same stringing method in hard mesh and soft mesh, it works in hard mesh but never in soft mesh!
Really frustrated when I have to string soft mesh...

and I thought it is better to string the top string from the 9D row but not the 10D row...

[sidewinder19]

buy some hard......

[itsthatkid]

Uhh, one tight weaved nylon near the very very top, then 3 decently loose laces three rows down, with no spacces in betwween

[MaKiMaKi13]

keep your pocket shallow because softmesh tends to bag out, and interlock everything, that and keep your shooters fairly loose or you might even switch them to all nylons

[egrlax10]

my evo pro had soft mesh, and i just had three rolled shooters in it and there was no whip.

[MACDADDY]

you have to have the top stretched tight so that the ball comes out smoothly.

[ShermanLax607]

The times that I have used soft mesh and have been successful is when I have 3 rolled, straight shooters. Apparently this helps the ball release more smoothly because there is less friction that weaved shooters and has less to get caught on. Just my 2 cents but definitely rolled>weaved, and no top nylon.

[laxlover8]

let me share more my experience in stringing soft mesh...
the top string: I have tried to add one nylon right below the lip, and it works Only if my nylon is a thick one.
the side string: this is the most troublesome part! even I do not double up the diamonds, there is still fiction in theo pocket. The ball just hard to leave the pocket even it is shallow.

[injinlax23]

if the sidewalls are done poorly it can cause it to throw bad
hard mesh it always good too