brine on warrior

[pmr149]

I know everyone is going to answer this question by saying "every head fits on every shaft". That is definitly true, to an extent though. Some wiggle and are real loose, while some are way to tight...I know a brand fits well on itself..and I actually noticed that stx fits well on warrior shafts, but how would the clutch (brine heads) fit on a warrior kryptolyte?

[BravesLaxer]

If some heads do wobble than just put a piece of tape around the top and then screw it on. So really I think it would fit fine.

[THALAX]

I find that basically any head will fit good on Warrior's Kung Fu Gripped shafts. If it is a little loose, then just do what BravesLaxer suggested, and wrap some tape around the throat.

[ChiLLax356]

I have a clutch on a kpro....perfect match except i had to drill a hole.

[Warrior]

I have a clutch on a kpro....perfect match except i had to drill a hole.


Question answered...